No Heat Affected Zones / No stresses from Cutting process

Narrow Kerf (~0.5 mm) possible with Pure Waterjet : very little material loss

No starting hole required

Wide variety of thickness up to 150 mm & Stack cutting

Extremely detailed geometry – Easy to Program

Low cutting forces (< 0.5 kgf. while cutting) :  Simple fixturing

Thin walls can be cut (~0.25 mm) : Close Nesting

Virtually burr free : Reduced secondary operations

Easy switch between pure waterjet & abrasive waterjet

One jet setup for nearly all abrasive jet jobs

Environmentally Friendly :No special disposal for used water with Garnet

Uniformity of Material not important to Waterjet Cutting